"1 Wire" 10 CM Male - Female
30 cm 1p Male to Female Wire
This wheel can be used to make Robot Car. It is made up of high-quality...
This M3x12mm hexagon pillar nut fits perfectly with the M3 hexagon pillars.
The KCD1-11-2P rocker switch is basically used to open and close an...
Insulating Tape Red
This card is compatible with LiPo and Li-ion 11.1V, 12V or 12.6V 3-cell batteries and has overcurrent, overload and oversize projection. It also has a low current consumption of less than 30uA.
Voltage indicator for 12V batteries. It uses a chip for voltage detection. Four LEDs of different colors are present on the PCB board, each indicating battery voltage. They are Red, Yellow, Yellow, Green, representing 20%, 50%, 80% and 100% respectively.