"1 Wire" 10 CM Male - Female
30 cm 1p Male to Female Wire
This wheel can be used to make Robot Car. It is made up of high-quality...
This M3x12mm hexagon pillar nut fits perfectly with the M3 hexagon pillars.
The KCD1-11-2P rocker switch is basically used to open and close an...
Insulating Tape Red
If you've ever ordered and wire up a 9-DOF sensor, chances are you've also realized the challenge of turning the sensor data from an accelerometer, gyroscope, and magnetometer into actual "3D space orientation"!
MS5540-CM Waterproof Depth Sensor Module Based on Presure (up to 100 m)
This compact module packs three IR LED/phototransistor pairs onto a 1.25″ × 0.3″ board. The sensors are mounted on a 0.375″ pitch, allowing this array to be used as a minimal detector for a line-following robot. Each sensor provides a separate digital I/O-measurable voltage output. See description for more details about the product. Add to cart now!
The QTR-1RC reflectance sensor carries a single infrared LED and phototransistor pair in an inexpensive, tiny 0.5" x 0.3" module that can be mounted almost anywhere and is great for edge detection and line following. See description for more details about the product. Add to cart now!
The module is a high-precision, 24-bit, and communicates with Arduino development plates on a two-wire protocol (clock thread and data thread). More information about the communication protocol can be found in the attached datasheet.